To keep your heat pump running at optimum efficiency; we recommend you clean the filters at least once every 3 months. In addition to this we recommend a service to be carried out by one of our experienced engineers. (approximately every 12 months, depending on usage and other conditions)
Annual checklist on indoor unit
- Clean main filter(s), wash and dry;
- Check electrical terminals for tightness;
- Check remote controller batteries and replace if necessary;
- Check condensate drain;
- Run in heating mode and check air off temperature 50C;
- Run in cooling mode and check air off temperature 6 to 8C;
- Wipe clean case and reassemble.
Annual checklist on outdoor unit
- Inspect unit case for corrosion and treat as necessary ;
- Clear any vegetation from under or around outdoor unit;
- Check electrical terminals for tightness;
- Leak check around flare joints and unit fittings;
- Tighten valve caps and access port;
- Clean down outdoor unit case and wipe clean.
- Rust protection spray on outdoor units.
The cost for this service is $95.00 per unit and $25.00 for any additional units per house.
To arrange for this service, please contact us.
